I'm trying to build in a Afterburner 040.
All cables are correctly soldered and as short as can be.
Heatsink of 040 cpu grounded.
The Flatcable wrapped in silverfoil, isolated and grounded.
I tried 4 different clockpatches with F7404 and F7408 chips.
The problem: Afterburner just doesn't boot.
My screen stays black.
(Falcon was tested before in 030 mode and works fine).
Note that i only try to boot in slow 020 mode. There's no software drivers installed yet.
I remember in the past this problem could happen to certain combinations of Falcon and afterburner.
There was a special hardware patch which could solve this.
Something to do with cutting a line of the DMA clock or so. (Not clock-patch)
I think Douglas Little invented it.
Please help someone.
Falcon Afterburner-Please Help! new
