Subject: RE: HiSoft Basic 2 cant see my FPU? |
Author: FatRakoon (79.121.141.25)
Date: 10-31-2007 03:49
Sure, I would be more than happy to do that.
Hang on...
http://www.fatrakoon.co.uk/hb2.zip
That should do you!!!
What I have done, is simply copied my entire HBasic2 Folder over, Removed my Source Directories and a few experimental PRGs etc, and the rest, I hope, is the rest of the HBasic folder.
This very one works straight off on the TT but fails to run on the Falcon...
Sorry, it fails to compile or run the source code, but the editor itself seem to run.
I know its silly, but on the ST, I had a hait of simply writing
TIME$="12:34:56"
DATE$="01/02/03"
and an ALT-X will set the time...
I did this on the Falcon and it wont even compile that!!!
Anyway, the above ZIP is 903K
Let me know what you think?
What I will try to do tonight, is take a photo of the screen when it dumps the registers, btu I have tried it before, to ask Rodolf about it, but I could not get a clear anough pic, so I might not be able to.
OK?
Thanks for this.
|