The 47r has gone on abso-effing-lutely spot on, and I am very happy with my first soldering job in 10 years ( Give or take )
The 3x33r are a bit of a shambles.
I have removed the wires, the Chip itself is superglued and so will have to stay, I will probably snip the legs off but its as-is for now.
There had previously been some confusion with R217 - this is the ZERO OHM Resistor, but under the spaghetti, I have now found R222, so now its clear that I dont touch R217 but R222 instead.
They way the Page printed out showed me R216, R217, R221 on one line you see...
I am still worried about R216 and the track that goes from the top to the left and then down... It looks like it goes through the board about level with the bottom of the Resistor, and there is a break in the track and then a pile of rubble that does not seem to want to shift... Im not at all happy with that, so thats not going to be fun.
R222 is untouched and R221 has been ripped out a bit harshly, but again, should not pose any threat.
I have not been bale to source some small resistors and I only hope that standard sized 0.6w jobs will be fine.