Subject: RE: Falcon + CT63 Still with issues? |
Author: FatRakoon (79-121-141-25.xln.managedbroadband.co.uk)
Date: 03-22-2008 21:48
I have gone around the Falcon testing it, and I am confident that the grounding is good.
The board, the sheilding and any and all contacts are clean and I am very happy with them.
The +5v to GND is showing me 2.9ohms and so that seems good.
CuBase works flawlessly as it has done since I got it upped to the CAF_060.PRG and I have taken the SCSI completely off and I am only running with one IDE HD.
So, Im trying to see if any particular HD Driver setting is or is not good.
After that, I will try out RAM, but teh very few programs that do work, work great.
Magic, Jinnee now run great, CAB 2.8 and HighWire are fine as is Papyrus and IMGCOPY4
and Kobold is also working just fine too... As a stupid test, I had this to use up all STRAM and it was perfectly able to copy 30GB of data from E: to H: and then I did the same with TTRAM and I copied the entire 440MB off D: onto H: and obviously, that would fill up the STRAM and then the TTRAM and it copied well enough, so that says the RAM is ok at least enough to have access to it.
QED on the other hand randonly hangs, or crashes the Atari, and hell, sometimes its fine, so WTF is going on there I dont know?
|