Author: Damion Jones (host213-1-97-220.btinternet.com)
Date: 05-02-2001 23:43
Ok, ok, So you can also get a 2U Rack as well then.
Personally, I would go for the Tower setup myself though, but this is only because I am a bit extreme in the upgrading department, and I recon if I could do it, I would house a calculator into a Towercase ( Hmmm, where is the casio?... )
Do the 2U rack mounts come with Keyboard cases?
Only, what I had to do, was either buy one for £70 or so quid ( No bloody way! ) or mash up the case, which means that I would be in the Shot ( Spelling mistake ) if I wanted to put it back, and I was not going to be stupid enough to pay £70 for s crappy bit of plastic, so out came the hacksaw, and files ( And Glue of course! )
And I used the ST's case to make one up!
All you need to do, is cut the back end off the case, I did it just where the grill thungy starts , and it looks ok. The wires going from the board to the keyboard are about 2 meters or so, not that I measured them or anything, but they are off an old joystick, and I just cut the originals, and re-wired then like that, so I didnt bother to get connections to make an extention ( Hey, I am on the dole! )
Nice job though! - I am Well chuffed with it.
|