Author: The Paranoid (kralle.zdv.Uni-Mainz.DE)
Date: 04-10-2002 11:10
I am pretty sure that some "lines" on the board need to be cut when installing an FX-card and uninstalling an FX means to reconnect those cut tracks.
Usually, this is being done with a solder-bridge, but that induces electrostatic noise and might lead to problems on "fragile" Falcons.
But you might be lucky and the ct060, now that it incorporates a bus-speeder, needs you to cut the exact same tracks on the PCB as well.
So i - personally - would wait until i have an instruction manual for the ct060 and see what is necessary to do.
Perhaps then you will just need to remove some wires instead of repairing cut tracks.
The Paranoid
|
